GPS coordinates: lat: -29.863489 - lng: 30.995541

Nic Instruments and Engineering (Pty) Ltd

Address:

13-15 Brand Road, 4062 Durban - Bulwer

Telephone:

(031) 202-7490

Fax:

(031) 202-7492

Description

NIC Instruments and Engineering (Pty) Ltd started in August 1986 and has developed a reputation in industry for the exclusive well known product brands it represents and the back up service offered with branches in Secunda, Vanderbijlpark, Rustenburg and Natal. Other areas are serviced with a distributor network
Complete System design of distribution reticulation systems up to 11KV.
Design of Motor Control Centres.
Design of Cable and Racking Layouts.
Design of Building Services including Lightning, Power Distribution, Earthing and Lightning Protection.
Project Management of Electrical Contracts.
Design of General Electrical Distribution and Utility Systems, including Power Factor Correction, Energy Management, Cable/Busbar Rating and Fault Level Design.
Supply and installation of Electrical Equipment in the Process and Building Industries.

Keywords

Engineering, Design, Construction, Systems, Valves, Tube, Pressure, Gas Detection, Detector, Level Measurement, Calibrators, Desiccant Testing

Company description

Electrical and Instrumentation Construction Division
In March 1988 Nic Instruments and Engineering (Pty) Ltd formed a new division and named it NIC Electrical and Instrumentation Construction which is situated at the same premises as Nic Instruments Johannesburg. The primary objective was to create a complete backup service for all our Products with the main thrust on correct installation and application.
Five years later the focus diverted to Electrical and Instrumentation Construction offering complete turnkey packages involving Supply, Installation and Commissioning.
Black Economic Empowerment
A Trust which owns 30 % of the Company was registered in early 2005 .
The members of the trust are the historically disadvantaged members of our staff working at NIC. Dividends paid out will be used to fund upliftment through education and other social and community programs.
Desiccant testing is done locally on the quality / life of your desiccant. An exothermic test is done on the desiccant as received, and also after a regeneration cycle. This is then compared to the required minimum expectations as well as against new desiccant. The samples are also checked for mechanical damage and oil contamination. Full reports will be forwarded for each sample that is tested. Samples should be taken from the top and bottom of both vessels for each dryer and clearly marked.
We can also supply desiccant to suit your needs for Compressed Air Adsorption Dryers.
NIC has fully committed, dynamic, competent instrumentation personnel with extensive experience, exposure and expert knowledge to take full responsibility for the different facets on a project.

Other Businesses: